Swim Spas represent unique challenges when it concerns covering them.
We can all concur that the swim spa needs to be covered when not in use for all the same reasons a hot tub needs a cover. The difficulty is that because of the length of the swim spa and the height of the sides, eliminating and replacing the cover can be a lot more difficult.
Getting a new swim spa is an exciting event in life. You’re anticipating the exercise you’ll get from using it. Possibly you’re a little relieved to have actually finally made a selection from the various models you took a look at. At any rate, you probably weren’t believing much about the cover you would use.
Usually, the cover that gets home with your brand-new purchase will be a 4 section stiff foam filled cover that will divide in the center and go off both ends.
No big deal.
Until it begins to get heavy.
Which it always does.
Every rigid foam filled Swim Spa Cover ever made ends up the same way and it is not the fault of the user. It’s a design defect. Built in obsolescence since as soon as it is positioned in use over the warm water in your swim spa it is inescapable.
It’s not from rain, so having a taper will not make any difference. In fact you could have it under a roof and the cover will still get heavy.
The factor is the steam from the water. The particles of steam are very little as they increase from the water surface. They make their method into the little fractures and crevices in the foam. Then as the steam cools it forms back into a liquid and ends up being trapped in the cover.

It takes place gradually and on a Swim Spa Cover which is made of private sections, at differing speeds. So ultimately you’ll observe one or two of the areas are really getting heavy. The bar lifters on the ends of the swim spa aren’t much assistance due to the fact that you still have to raise that heavy cover back up onto the spa which is a lot higher than a routine spa.
This is why SpaCap.com came up with a various style for their Swim Spa Covers
Instead of using numerous foam panels to construct Swim Spa Covers that will eventually wind up in some landfill, they developed one that utilizes air chambers that do not suck up moisture.
In fact SpaCap.com Swim Spa Covers are lightweight, insulate better, won’t blow away in a wind storm or be harmed by snow or hail.
Covered with Sunbrella Marine material, these covers will not fade, or break down at the seams either. So if you own a swim spa, and you mean to keep using it daily, SpaCap.com has the Swim Spa Cover for it.
If you’re not prepared to order today, bookmark this website so you can find it once again when you’re prepared!